Repair Tools

Handcrafted in our workshop, this key is used to disassemble and reassemble the buttons of your accordion.

It is suitable for all right and left hand accordion buttons, from 8 mm to 16 mm.

Warranty: 5 years

Handcrafted in our workshop, this key is used to disassemble and reassemble the buttons of your accordion.

It is suitable for all right and left hand accordion buttons, from 8 mm to 16 mm.

Warranty: 5 years

Handcrafted in our workshop, this key is used to disassemble and reassemble the buttons of your accordion.

It is suitable for all right and left hand accordion buttons, from 8 mm to 16 mm.

Warranty: 5 years

This clamping handle works with accordion bass buttons ranging from 
9 mm to 9,5 mm in diameter.

This clamping handle works with accordion treble buttons ranging from 
14 mm to 15 mm in diameter.

Accordion waxing tool traditionally used by Italian craftsmen.

These pliers are a tool used by accordion makers and repairers to remove the pins that connect accordion bellows to the right hand or left hand case. The tip offers a good grip and the best way to extract a pin without damaging it.

This tool is used to adjust the mechanics of the accordion's treble.

This tool is used to adjust the right hand mechanics of the accordion and get them aligned with the holes of the soundboard. There is also a tool for adjusting the height and angle of the valve (see below).

This crowbar can be used to fine tune the mechanical parts of the accordion's bass side. Available in two sizes, thin and large (see below).

This crowbar can be used to fine tune the mechanical parts of the accordion's bass side. Available in two sizes, thin and large (see below).

These pliers are a tool used by accordion makers and repairers to fix the bellows corner securely. Its tip allows the tightening of the corner against the bellows in order to permanently block it, and without it being opened as is the case with a flat pliers.

Fine and light hammer, suitable for nailing reeds to box springs.

Length: 25cm

Weight: 175g

Handle diameter: 2 cm

For manufacturing and modifying springs, allows you to perform 4 types of rounding very cleanly.

5 pliers for handling thin parts:

1 small pointed pliers

1 large pointed pliers

1 self-tightening pliers

1 flat pliers

1 angled pliers (pointed)

Perfect for small repairs requiring quick and efficient bonding.

Perfect for small repairs requiring quick and efficient bonding.

1.5 cobalt drill bit, perfect for making the hole into which the buttons will be screwed.